MY词语>英语词典>transition radius翻译和用法

transition radius

英 [trænˈzɪʃn ˈreɪdiəs]

美 [trænˈzɪʃn ˈreɪdiəs]

网络  过渡半径

机械

双语例句

  • The Optimal Design with ANSYS for the Circular Arc Transition Radius of the Shaft Collar of a Circular Shaft in Torsion
    利用ANSYS软件对扭转条件下圆轴轴肩圆角的优化设计
  • This thesis introduces the method of optimal design for the circular arc transition radius of the shaft collar of a circular shaft with ANSYS, which has an important use value in engineering practice.
    介绍了利用ANSYS软件对圆轴轴肩圆角进行优化设计的方法,在工程实际中有重要的应用价值。
  • Moreover, in the phase transition process it was found that the size and assembling degree of the product decreased with the increase of rare earth ions concentration or radius.
    而且在相变的过程中,导致产物形貌组装程度及粒径均随着稀土离子半径的增大或浓度的增加而显著降低。
  • The computation results show that there exists serious stress concentration on the fractured section of the shaft. The main reasons of high frequency fatigue fracture of the shaft are that the small transition radius and the tensile stress caused by the tightening torque of the bolt.
    结果表明,花键轴断裂处存在严重的应力集中,花键轴断裂处过渡圆弧半径过小以及未对螺栓拧紧力进行控制是导致轴产生高周疲劳破坏的主要原因。
  • Dynamic curve negotiating is simulated, in order to ensure the effect of length of transition curve line and radius of curve to the vehicle dynamics curve performance.
    对货车进行曲线通过仿真计算,通过改变线路的缓和曲线长度和曲线半径,分析其对车辆曲线通过动力学性能所产生的影响。
  • In this paper. the authors give the calculation formula of the length ( L_ ( 0)) of transition curve and the radius ( R) of circular curve.
    本文详尽地推演了公路凸型曲线中的缓和曲线长度L(0)和圆曲线半径R的计算公式。
  • We know it will cause a vapor-liquid transition or switch between open and closed when change the radius of the nanotube or the channel-water interaction is triggered.
    我们知道,改变纳米通道的半径或者纳米通道和水之间的相互作用,将会引起纳米通道内的汽液相变和开关状态的转换。
  • Principle and algorithm of linear transition cutter radius compensation
    直线过渡的刀具半径补偿原理及算法
  • When the transition arc is ground the distance between the gyration center of the transition arc and the surface of the grinding wheel must be equal to the gyration radius of the transition arc identically.
    磨削刀片过渡圆弧时,过渡圆弧的回转中心到砂轮面的距离必须恒等于过渡圆弧的半径,磨削过渡圆弧的复合运动要保持过渡圆弧的回转中心沿平行于砂轮面的直线运动;
  • An Estimating Stability Constants of transition Metal Amino Acids Complex from Cation Radius
    由阳离子半径估算氨基酸过渡金属络合物稳定常数